Polaris RZR 800 Rear LED Light Mounting Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket that attaches to the 1.75" roll cage and allows for rotation of LED Lights for a Polaris RZR
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 295
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This goes along with the top mount LED bracket I made and the roll cage mounting brackets… I wanted to put the rear lights on the roll cage so I made a bracket to do it.
There's two designs… the first one has a 5/16" bolt through the middle, the second the 5/16" bolt is offset. I wanted to have some ability to turn the brackets and reposition them. The first one I thought would be fine since I could set the angle of the lights up and down, or if I wanted to go side to side, I'd just rotate the whole bracket 90degrees. I didn't like it, though, since i wanted more to be able to adjust up and down with the lights, and in doing so, the one light hung out the side of the RZR. I was worried it would get clipped by a tree branch and pulled off. So I made the second mount that was offset. The first one also kind of bent in where the ¼-20 bolt holds the rotating light part to the center bracket, so I added some material around the teeth to straighten that out. They're pretty solid.
I debated using the bracket with the lights that was curved and had some adjustability, but I didn't really think I'd be changing these all that much once I had them set initially.
I used the “fuzzy skin” feature in Prusa slicer to give some texture to the part of the bracket that mates with the roll cage bracket, the part where the 5/16 bolt goes through. That way you can turn it all around and still get some good friction to hold it in place.