1 / 7
48mm Hood for W-Nikkor 3.5cm f/1.8 Nikon S Rangefinder Lens — zdjęcie 1
1 / 7

48mm Hood for W-Nikkor 3.5cm f/1.8 Nikon S Rangefinder Lens

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Vented Lens Hood for the W-Nikkor 3.5cm f/1.8 Nikon Rangefinder S-mount Lens

Ocena
0 / 5
Polubienia
6
Pobrania
47
Wydruki
0
Wyświetlenia
322
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Information

This is a lens hood for the W-Nikkor 3.5cm f/1.8 rangefinder lens (in Nikon S mount). It should also fit on the rare third version of the 3.5cm f/2.5. It uses a M48 X 0.5 filter thread.

"Why does it have all those holes?" On rangefinder cameras, the viewfinder is offset from the lens, and a large lens hood can obstruct your view of the scene. This is especially problematic on Nikon rangefinders, where the viewfinder is as close as possible to the lens. Adding an angled vent solves this issue without introducing opportunities for lens flare. Most lens hood vents have a long ovular shape, but this wouldn't be possible to 3D print without supports, introducing extra complications. I opted instead for circular cutouts. Since the lens hood rotates when the focus or aperture changes, I opted to place them very regularly. The downside is that they are a bit of a torture test for printers. So, good luck!

The front of the hood is designed to fit generic 58mm lens caps. There's still room to use the lens' inner 43mm filter thread, but if you have a very thick filter it may need to be shaved down to fit.

Print Settings

Orientation: Face down, no supports needed

Nozzle: 0.4mm (0.2mm possible with PLA)

Material: PETG-CF (PLA should work fine)

Layer Height: 0.12mm

Due to tight tolerances, you may need to make adjustments to the layer height to get the threads to come out nicely.

Tagi