Ugreen Nexode 65W Mount with Screw holles
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for the UGREEN Nexode 65W 4 Port this simple mount allows you to atach your charger anywhere with screws
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 25
- Wydruki
- 1
- Wyświetlenia
- 298
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Printing Instructions
Filiment
Print in a durable slightly flexable filiment like PETG though PLA may be good enough
Slicing
print vertically back to the build plate
no supports required
V1 or V2
the differnce bettween V1 and V2 is the addition of slotts so you can screw in your screws most of the way before mounting the part and then slot it on before tighting all the way down
Instalation Instructions
Step 1
Present the part to the surfice you wish to atach it to then. Use a pencil to mark the screw holes
Step 2
Remove the part and drill the holes
Step 2.5 (if using V2)
Install the screws in to the holles leaving a few mm of clearence to slide the lip under
Step 3
Screw in the screws in to the holles using the hole in the bottom of the part to get access with the screwdriver as pictures
Step 4
Slide the charging brick in to the mount there will be some ressitance as the feet locate in the holes with an interferance fit.
Step 5
Plug in the cable at the back
