Adams Rite 25-0471-IP End Cap (Hinge) Door Lock - Push Release End Cap HX0471

Warning! Do not attempt to sell these as the original is likely patented. I designed this after seeing they were around $18 each after tax on Amazon. This is an end cap that closely matches the Adams Rite 25-0471 or HX0471. It also has many other models listed. The biggest difference is that I didn't round the front off, but this doesn't affect functionality and the look is minimally different. Internally, everything lines up and this is a great replacement for your broken end caps. This took a few hours of work to get the measurements down to the fraction of a millimeter. I ended up printing this in some cheap black PETG in the position shown when you open the STL. I chose support for enforcers only and it was the easiest and fastest way to print this with minimal cleanup. There is a small overhang that had minimal stringing that I removed and lightly sanded. It only took a few minutes vs. printing with full supports. I recommend a 40%+ infill, but it is decently solid all the way down to 20%. The only exception with 20% was the front-facing part, which is face down in the STL for printing, shows the infill lines lightly. For a more finished look, increase your infill.

Plastic Hinge End Cap Assembly for the following Adams Rite Exit Devices:

• SVR Exit Devices: 8100, 8200

• Mortise Exit Devices: 8300, 8400

• CVR Exit Devices: 8500, 8600

• Rim Exit Devices: 8700, 8800

• Midpanel Exit Devices: 8475, 8675

• Push Bar: 8099/8099M