1 / 10
Deye 8 kWt inverter exhaust mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
120mm exhaust fan mount for Deye SUN-8K-SG01LP1 (and potentially similar inverters) to enhance its active ventilation
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 1470
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Reduces the inverter temperature and prevents the buit-in (and noizy) cooling system from activation. No additional mounting required. No supports required.
Hardware:
- 4 pics 92x92x25 fans (e.g., NF-B9 redux-1600 PWM )
- 4 pics M5*12 bolts
- 4 pics M5 nuts
- 4 pics M3 copper embedment nuts (e.g., M3, OD4.5mm, length 4mm )
- Fan speed controller (PWM-based)
Recommendations & Printing Sequence:
- Print the "Middle" part first
* Check if it fits the ventilation holes. It should be a snug fit.
* Tested on a Bambu Lab P1S — fits perfectly.
- Print “Top”, "Top Cover" and “Bottom” parts.
- Melt in the embeded nust into the “Top” part and drill a hole
* Note: There are no pre-made holes in the “Top” part for a power supply connector.
* You can drill or cut manually, or apply a negative volume in the slicer according to your setup.
- Asseble all 3 parts using M5 bols and nuts.
- Secure the fans with scrues that provided in the set.
Note: I had some challenge doing this, some effort might be required.
- Install the PWM controller or microcontroller.
* In my case, I used an ESP8266 integrated with Home Assistant(ESPHome) and Solarman, so fan speed is dynamically adjusted based on the inverter’s temperature.