1 / 10
Deye 8 kWt inverter exhaust mount — image 1
1 / 10

Deye 8 kWt inverter exhaust mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

120mm exhaust fan mount for Deye SUN-8K-SG01LP1 (and potentially similar inverters) to enhance its active ventilation

Rating
5 / 5
Likes
10
Downloads
77
Makes
1
Views
1,470
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

Reduces the inverter temperature and prevents the buit-in (and noizy) cooling system from activation. No additional mounting required. No supports required.

Hardware:

  • 4 pics 92x92x25 fans (e.g., NF-B9 redux-1600 PWM )
  • 4 pics M5*12 bolts
  • 4 pics M5 nuts
  • 4 pics M3 copper embedment nuts (e.g., M3, OD4.5mm, length 4mm )
  • Fan speed controller (PWM-based)

    Recommendations & Printing Sequence: 
  1. Print the "Middle" part first
    * Check if it fits the ventilation holes. It should be a snug fit.
    * Tested on a Bambu Lab P1S — fits perfectly.
     
  2. Print “Top”, "Top Cover" and “Bottom” parts.
     
  3. Melt in the embeded nust into the “Top” part and drill a hole
    * Note: There are no pre-made holes in the “Top” part for a power supply connector.
    * You can drill or cut manually, or apply a negative volume in the slicer according to your setup.
     
  4. Asseble all 3 parts using M5 bols and nuts.
     
  5. Secure the fans with scrues that provided in the set.
    Note: I had some challenge doing this, some effort might be required.
     
  6. Install the PWM controller or microcontroller.
    * In my case, I used an ESP8266 integrated with Home Assistant(ESPHome) and Solarman, so fan speed is dynamically adjusted based on the inverter’s temperature.

Tags