10 inch rackmount - Beelink EQ14 MiniPC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
10" rackmounts for the Beelink EQ14 MiniPC, with or without keystone slots
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 106
- Wydruki
- 2
- Wyświetlenia
- 485
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a fitted 10" rackmount for the Bee-Link EQ14.
It has cutouts for ventilation, and a bottomless design to accomodate the router without going over 1U in height.
Required hardware:
Screws and cage nuts that came with your cabinet, nothing else.
Current variations:
Fitted version for the EQ14.
Fitted version for the EQ14 with two Keystones, one on each side.
Fitted version for the EQ14 with three keystones on the right side. Specifically intended to connect external drives to the USB 3.2 Gen 2-ports on the back. These ports also have a label.
Printing instructions:
Strength at your discretion. I printed with the following settings:
- 3 perimeters
- 25% infill
- Gyroid
- PETG (for heat resistance)
Print either flat or on its face. Flat should give better structural integrity in terms of layer orientation. I have printed mine standing on it's face in order to get the textured plate pattern on the front.
Will fit a Prusa MK3/4/Core One if you place it with its face down.