3rd Party AD5M Nozzle Connector Puller
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For easy pulling out the 4 pin XH connector for any 3rd party AD5M nozzle.
- Ocena
- 4 / 5
- Polubienia
- 21
- Pobrania
- 84
- Wydruki
- 0
- Wyświetlenia
- 585
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Those four wires on various 3rd party AD5M Nozzle's 4pin XH connectors are very flimsy especially those two heat sensor wires. There's no easy way to disconnect the 4-pin connector except by by pulling those wires and I already broke two sets of heat sensor wires.
That's why I make this little puller to help removing the connector in a safe manner.
Use a ≤0.4mm nozzle to print the model out. PETG is a must because PLA will become brittle overtime because of the heat.
Print setting:
Arachne wall generator. One wall on top. No brim.
Instruction:
Pre-bend the stripe part a little for the first time. Always pull out the connector first before the nozzle.
Check if the XH connector still has the arrow shape latches intact. Remove them with a craft knife if the manufacturer forgot to remove them. The latches SHOULD NOT be there in the first place.