Soothie/Wubbanub Pacifier Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a pacifier cover to protect the business end of a Soothies pacifier from the elements while it's not in the…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 409
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This is a pacifier cover to protect the business end of a Soothies pacifier from the elements while it's not in the babys mouth. It snaps over the whole rubber part, and stays on pretty well even while being jostled around.
Update 3/3/2019:
Added a loop to the cover (v11) so it can be attached to a pacifier clip, or anything else to keep it handy while not in use.
Update 5/23/2021:
Added v12 which has larger tabs and they are rounded to make it easier to pull out the pacifier and reduce sharp corners.
Print instructions
Category: Household Print Settings
Printer Brand: Anet
Printer: A8
Rafts: No
Supports: No
Resolution: .1
Infill: 0%
Filament: Shaxon PLA Red
Notes:
Used Cura 3 for slicing and it did not use any retracts, which made it nice and clean on the inside without any stringing.