Motorola Edge 50 Neo - Case

A TPU Case for the Motorola Edge 50 Neo with full camera lens protection.

Because of the camera bump, the model is divided into two parts which you have to glue together.

I tried a number of glues, this one worked very well on TPU:

                                                                                                        Pattex Special Plastic

 You could also try normal superglue, but I figured a more flexible glue will last longer in daily use.

In order to perfectly align the camera holes, I glued with the phone in place. Of course, protect it with some tape!

There also is a little helper file that helps you put some weight right above the contact surfaces. But it is not strictly needed. If you use the same glue as me, duration is less important than peak pressure.

On my phone, I installed a Screen Protector of about 0.6mm thickness, so I made the border a bit high. But there is also a version with lower border included.

Right out of the box, the buttons are hard to press and lost a lot of their feel. But you can improve it greatly by cutting in the areas marked in red.

Also, there may be sharp edges on the underside that are uncomfortable in the hand. I placed tape up to the edges and used a heatgun to soften them. If you are careful you can also use a knife to blunt them.

                                                                               Have fun!

Material: TPU. Mine was 95A Shore Hardness, I'd recommend a bit softer.

Supports: Yes, under the top edge. Be patient removing them, sadly it's needed.