Creality Ender 3 V3 SE Quiet Toolhead Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a toolhead cover that integrates a NF-A4x10 24V and a 5015 blower for quite operation
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a toolhead cover that integrates a Noctua NF-A4x10 24V and a 5015 blower for much quieter operation.
I originally had these fans just bolted on with some other mods, but wanted an integrated cover for a cleaner look.
Print with at least 3 walls out of the most heat resistant plastic you have. You can probably get away with PLA (especially if annealed) but it might deform over time. I used polycarbonate.
Can be printed without supports. Print the main case with the front face on the build plate and print the fan duct with the wide opening on the build plate.
To assemble,
6x 20mm M3 screws for all the fan mounting screws.
The front fan should screw in from the front, with the screws going all the way through the fan holes and attach the fan guide to the rear of the fan.
The lower screw hole for the 5015 blower just screws into the plastic, the upper hole should align with the top-left hole of the extrude motor.
The remaining 2 screw holes should attach the the original cases mounting holes on the metal frame with the original screws.
The dimensional accuracy is pretty tight for all the screw holes to align correctly. I've included the .3mf if you need to tweak the positions for your setup or to account for warping.