1 / 3
[Gridfinity] Shokz OpenFit Air / Airpods Holder — zdjęcie 1
1 / 3

[Gridfinity] Shokz OpenFit Air / Airpods Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a 1x2 magnetized Gridfinity bin to hold a Shokz OpenFit Air headphone charging case.

Ocena
0 / 5
Polubienia
6
Pobrania
42
Wydruki
0
Wyświetlenia
362
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a 1x2 magnetized Gridfinity bin with tabs to remove magnets, that have been installed the wrong way around. It is made to hold a Shokz OpenFit Air headphone charging case and apparently fits Airpods housed in the extra thick Spigen casing (see base model).

I used the base model's negative space to craft a new gridfinity base for my nightstand gridfinity setup.

I printed it with 10% gyroid infill and 2 walls (my default gridfinity setup) on plain old Sunlu PLA+. It should print in pretty much any hard filament without supports.

Magnets are optional. I use 6x2mm round magnets.

Tagi