[Gridfinity] Shokz OpenFit Air / Airpods Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 1x2 magnetized Gridfinity bin to hold a Shokz OpenFit Air headphone charging case.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 42
- Makes
- 0
- Views
- 362
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 1x2 magnetized Gridfinity bin with tabs to remove magnets, that have been installed the wrong way around. It is made to hold a Shokz OpenFit Air headphone charging case and apparently fits Airpods housed in the extra thick Spigen casing (see base model).
I used the base model's negative space to craft a new gridfinity base for my nightstand gridfinity setup.
I printed it with 10% gyroid infill and 2 walls (my default gridfinity setup) on plain old Sunlu PLA+. It should print in pretty much any hard filament without supports.
Magnets are optional. I use 6x2mm round magnets.