CMF Phone 1 DACback backJACK
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3,5mm Jack connector backpack plate for Nothing's CMF Phone 1
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 213
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Behold - my first model made for CMF Phone 1, a rear mounted frame for DAC (or USB-C and 3.5mm jack connector). Simple and needed upgrade that can provide an upgrade to have a fully functional 3.5mm jack to connect your wired headphones. Done in FreeCAD, can be printed in any filament, in my case - best results came with PETG with 0.16mm layer.
Fuzzy skin can be used to hide seams, but remember to use it only on main (outer) body.
A longer M2 screws may or may not be needed. In my case - as i'm using printed case with thinner back - original screws fitted, hooked with 3 thread rounds, so longer screws was not used.