Giant underdesk cabinet with 2 drawers (with optional Gridfinity insert)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a huge underdesk drawer which should be able to hold a lot.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 571
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
You need drawers under your desk and have a lot of stuff to put in there? Well, then this might be what you were looking for!
This is a big drawer cabinet which can be glued or screwed underneath your desk (if there is enough space underneath).
The cabinet has lots of space (for an underdesk drawer).
Note: Even though the model does use holes to reduce filament, it is still using a lot of filament. The frame alone is close to 1KG spool.
I printed the outer shell and the rails in PETG and the drawers in PLA.
Note:
- I do have two different upper drawers, one full and one with a separate divider to allow a tabletop rail to have space inside the drawer element.
- There are two main boxes, one uses a bit less filament, but it is tricky to print and prints much longer.
- I did print the drawer multiple times. The second incarnation had a stuck filament at the printer towards the end and I created a special front to make use of it anyways (see picture). However - as it is highly unlikely that you would get into the same situation, I did not upload that model.
Extensions
I created many months later to the underdesk cabinet and / or the lower drawer:
- If you encounter that the drawer element might shift when pulling a drawer, you can add the drawer lock.
- Furthermore I created a Gridfinity inset which can be downloaded from here.
- And there is also a drawer in drawer for screwdrivers which can be downloaded from here.