1 / 1
BoxTurtle rear right skirt for CNLINKO 4-pin connector — zdjęcie 1

BoxTurtle rear right skirt for CNLINKO 4-pin connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the BoxTurtle part to fit a CNLINKO M12 4-pin female bulkhead connector LP-12-J04SX-02-401

Ocena
0 / 5
Polubienia
3
Pobrania
10
Wydruki
0
Wyświetlenia
154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of the original BoxTurtle part. It allows you to use a CLINKO M12 connector for the cable that runs between the BoxTurtle and the printer's main board. It's up to the builder to work out the details, but my planned configuration:

  1. CANBUS cable from the M12 to the BoxTurtle control board
  2. M12 connector installed on the printer and connected to a BigTreeTech CANBUS hub over CANBUS cable.
  3. A short M12 male to M12 male cable connects the BoxTurtle to the printer.

M12 connectors here: https://www.amazon.com/Cnlinko-Waterproof-Connector-Plastic-Medical/dp/B0877YG7KZ

Tagi