1 / 1
BoxTurtle rear right skirt for CNLINKO 4-pin connector
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a remix of the BoxTurtle part to fit a CNLINKO M12 4-pin female bulkhead connector LP-12-J04SX-02-401
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 155
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
This is a remix of the original BoxTurtle part. It allows you to use a CLINKO M12 connector for the cable that runs between the BoxTurtle and the printer's main board. It's up to the builder to work out the details, but my planned configuration:
- CANBUS cable from the M12 to the BoxTurtle control board
- M12 connector installed on the printer and connected to a BigTreeTech CANBUS hub over CANBUS cable.
- A short M12 male to M12 male cable connects the BoxTurtle to the printer.
M12 connectors here: https://www.amazon.com/Cnlinko-Waterproof-Connector-Plastic-Medical/dp/B0877YG7KZ