1 / 4
Fan bracket for Hoymiles HMS1600-4T micro inverter — zdjęcie 1
1 / 4

Fan bracket for Hoymiles HMS1600-4T micro inverter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

During a load test, the passive cooling was insufficient, which meant that active cooling was required.

Ocena
0 / 5
Polubienia
2
Pobrania
105
Wydruki
0
Wyświetlenia
673
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

📄 Fan bracket for Hoymiles HMS1600-4T micro inverter

 

✅ Compatibility

This clip-on bracket is designed for the Hoymiles HMS1600-4T microinverter and potentially other HMS/HMT models.
 

The inner width of the slot (fit over the cooling fins) is 106.6 mm – please check this measurement on your inverter for compatibility.
The opening width of the clamp is 40 mm, meaning only the inverter housing width needs to be measured for a quick check.

 

🔧 Mounting Details

The bracket slides onto the cooling fins without any tools, drilling, or modifications.
It supports two standard 120 mm fans, mounted with a 20 mm offset from the housing.
Mounting holes are prepared for M4x30–35 mm screws and M4 insert nuts (suggested: 5–8 mm long).
The fans should be protected against dust and splash water in order to maintain their service life.

 

Note:

The fans can be operated as required via a small solar panel with PWM temperature control or via Smart Home (e.g. Shelly or similar) depending on the temperature measurement.

I myself use an old PTC control board (12V PWM Fan Control @Amazon.de) with an 18V solar panel and a remote temperature sensor which was on stock from another project. I also mounted an aluminium metal sheet in front of the fans to protect them from environmental influences. Although the fans are originally intended for PC use, I hope they will last long enough for outdoor use.

 

 

🛠 Recommended Print Settings

  • Material: PETG or ASA for outdoor durability
  • Infill: ≥ 30 %

 

🌦 Use Cases

  • Avoiding power derating due to high temperatures (> 65 °C) and increase service life by activly cooling the microinverter.

 

🧩 Design and Functionality

  • Robust clamping mechanism holds firmly to the cooling fins
  • Extended frame design allows full-size 120 mm fans
  • Tool-free installation

 

📋 Materials List

  • 2× printed fan bracket (this model)
  • 2× 120 mm fans with 105 mm distance to the mounting holes, preferably with closed motor housing
  • 8× M4x30–35 mm screws
  • 8× M4 heat-set insert nuts (5–8 mm)

 

🔗 Related Models in My Collection

Currently none 

 

📦 Compatibility & Credits


Feel free to remix or adapt it — feedback welcome!

 

I will add a few more pictures soon. The uploaded picture is from the first try on.

Tagi