Dreo Remote Tactile Buttons
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A few raised symbols to glue on a Dreo tower fan remote, since it's impossible to tell what you are pressing in the dark
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a few raised symbols to glue on my Dreo tower fan remote since it's impossible to tell what you are pressing in a dark room. They are 1.5mm high.
“+/-” symbols for lower/raise fan speed
“o” to toggle oscillation
I didn't do the rest since I rarely use the timer or sound mute. And the “mode” button is now easy to feel between the “-” and “o”
Printed in PLA at .08 layer height. Took about 7-8mins.
Since these are so small, you need to use the small layer height, and you may need to turn on “detect thin walls."
It could be neat if you used glow-in-the-dark filament.
How to apply:
I thinly spread some super glue on a scrap piece and then gently dipped the bottoms of the prints in the glue with a tweezer to place on the remote.