Dji RC2 Self-Balancing Neck Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount with arms and knurled screw adapter (M4x20mm) to hang DJI RC2 level using neck strap easy to attach/remove
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 121
- Wydruki
- 0
- Wyświetlenia
- 560
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a self-balancing mount for the DJI RC2 remote controller, designed to let it hang level when attached to a neck strap. It consists of two plastic arms that screw into the existing mounting holes on the controller. Each arm has a hole for a neck strap (4mm in diameter), shifting the center of gravity so the controller stays horizontal—even when not held in hand.
Also included is a small model to insert an M4x20mm hex nut and convert a standard M4 screw into a thumb screw. This makes it easy to attach and remove the arms on the go—no tools needed.
Ideal for drone pilots who want hands-free access to their screen while keeping the controller steady and visible.
needed parts:
- M4x20mm hex-screw
- rope (approx. Ø4mm diameter)
printing:
- PLA is fine but PETG propably better
- print in full perimeters or 100% infill
- minimum 0.2mm layer height (0.1mm recommended)
- supports: I recommend to use supports for the hex inserts and screw holes on the arms (organic)
- use a brim if you dont have the best adhesion
assembling:
- put the screws in place (you might have to use a bit force for them to properly fit)
- put the rope through the holes and make a knot on the flat end side of the arm (if you use a synthetic rope you can burn the ends to melt them)