1 / 2
Formbot Voron 2.4 Runout Sensor and Bowden Tube Holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Voron 2.4 bowden tube holder revised to include a filament runout sensor, using only parts from Formbot's sensor
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 263
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
A basic Voron 2.4 bowden tube holder, modded to include a filament sensor, relying ONLY on parts harvested from the runout sensor provided by Formbot in their kit.
I wanted a filament runout sensor and didn't like (nor understand) the runout sensor provided by Formbot with their kit, so I designed this model specifically to:
- Not deviate (much) from Voron's stock parts and appearance
- Not require any new hardware (besides what was included with the Formbot kit)
- End with a working runout sensor
Required Hardware:
- Formbot filament runout sensor, specifically the following components:
- MR85 bearing
- PCB (Omron switch + connector)
- 2 self tapping screws
Build Procedure:
- Print this part
- Completely disassemble all parts from the stock Formbot runout sensor (don't remove anything from the PCB)
- Put the MR85 bearing into the printed part (should see a slot that's about the same size)
- Push the PCB into the printed part, covering the bearing, such that the switch's trigger is aligned with the bearing
- Use two screws to screw the PCB into the printed part
- Attach the printed part to your Voron in the same place the bowden tube holder would have gone
- Push the reverse bowden tube into the printed part until it stops (larger hole)
- Attach cable from runout sensor to your mainboard (can zip tie the cable to the 3d printed part if you want to be fancy)
- Configure Klipper to utilize your sensor