1 / 2
Formbot Voron 2.4 Runout Sensor and Bowden Tube Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Voron 2.4 bowden tube holder revised to include a filament runout sensor, using only parts from Formbot's sensor
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 19
- Makes
- 0
- Views
- 263
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Public Domain
A basic Voron 2.4 bowden tube holder, modded to include a filament sensor, relying ONLY on parts harvested from the runout sensor provided by Formbot in their kit.
I wanted a filament runout sensor and didn't like (nor understand) the runout sensor provided by Formbot with their kit, so I designed this model specifically to:
- Not deviate (much) from Voron's stock parts and appearance
- Not require any new hardware (besides what was included with the Formbot kit)
- End with a working runout sensor
Required Hardware:
- Formbot filament runout sensor, specifically the following components:
- MR85 bearing
- PCB (Omron switch + connector)
- 2 self tapping screws
Build Procedure:
- Print this part
- Completely disassemble all parts from the stock Formbot runout sensor (don't remove anything from the PCB)
- Put the MR85 bearing into the printed part (should see a slot that's about the same size)
- Push the PCB into the printed part, covering the bearing, such that the switch's trigger is aligned with the bearing
- Use two screws to screw the PCB into the printed part
- Attach the printed part to your Voron in the same place the bowden tube holder would have gone
- Push the reverse bowden tube into the printed part until it stops (larger hole)
- Attach cable from runout sensor to your mainboard (can zip tie the cable to the 3d printed part if you want to be fancy)
- Configure Klipper to utilize your sensor