DAP 2U cage for NUC/SFF with VESA
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Maximized 2U DAP panel cage for smaller computers in NUC or MFF. As an extra there are rails for Vesa mounts.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 133
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
2U DAP panel cage for smaller NUC/MFF computers
This is a maximized holder of computers of many sizes into DAP panels where the holders can be mounted with Vesa 75 || 100 plates for extra stability. DONT FORGET washers for the screws/nuts for the underside, this will increase the friction and mitigate the plastic budging.
I printed my parts in PETG (different colours and makes.) which took around 5 hours for the cage and 19 min for the faceplate.
Two part layout
Due to all computers being different this setup is split into two parts. Main part is the cage:
… while the other is the panel faceplate.
The idea is that the faceplate is push into place by the computers mounting and gives you the correct access to the buttons/front I/O as desired. There is also a blank faceplate which easily be modified in any slicer to fit your preferences.
No supports needed but…
While no supports are needed to print this standing the vesa rail pillar might become unstable and I recommend pausing the printing after ¾ of the bottom hexagon completion and place a piece of tape. This will stop the pillar from shaking and disrupting the print quality.
Prevent this….
…by doing this
