1 / 8
JetKVM Magnetic Feet Case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for the JetKVM with inserts for 8mm x 3mm circular magnets
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 410
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (10)Powiązane
A quick remix I created in Tinkercad from the original "JetKVM case - magnetic feet".
This remix adds an additional circular insert for 8mm x 3mm magnets. The magnets I used for this model are located here at this Amazon link: (Amazon USA) 40pcs 8x3mm Small Round Refrigerator Magnets
I also cleaned up the original model and removed various micro gaps and inconsistencies with the symmetry and overall appearance.
Suggested Print Settings:
This model takes very little filament to print (~27g)
- PETG/Temperature Resistant Material
Could be printed using PLA or similar material, but if using inside of a computer case or hot location, PETG or other similar temperature resistant material is suggested. - All/Maximum Perimeters
Selecting around 6 perimeters in your slicer should work fine, the goal is that this model should be printed entirely of perimeters with no infill, for maximum strength. - No Infill
- Supports Enabled - Organic/Tree
- 0.2mm - 0.15 Layer Height