Minisforum V3 Clip Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my custom designed Clip Case for the Minisforum V3 Tablet, designed to print easily on my Creality K1C.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 851
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my case design for a Minisforum V3 Tablet, designed to be printable on my Creality K1C's 235x235 print bed.
You'll need to print:
2 back plates
2 frames
4 feet
2 clips
The back plates need to be glued to the frames, I used super glue and started with letting a corner dry, then the short edge, then the others one at a time, being careful to keep it aligned before it sets.
I added some guides on the back plates for aligning the clips and feet, but they aren't perfect, so I put them in the “versions” folder if you want to try them out. There's also solid models of the tablet - with and without keyboard slots - so you can chop it up as you please for your own printer sizes. I cut the release version to minimize supports due to MANY failed prints.
I've only printed this in PLA so far, but I expect once the tablet gets warm there might be some deformation.
DISCLAIMER
You are solely responsible for the safety of your device. I do not guarantee that this case will protect your device from a fall, bump, toss, or even a low-speed collision with a feather. It is absolutely not waterproof, nor is it edible. Do not leave in the presence of children - that tablet is expensive!!!