1 / 3
custom clicky probe for V slot mounting (and sapphire sp-5 with enclosure)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
servo mount, clicky probe adapter and arm to install a variable clicky probe
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
inspired by the original clicky probe mounts and parts. I just didn't like how they interfaced and how loose the probe was held in the arm.
This mount uses slightly larger (15kg / DT996) servos as I tried it with smaller (MG90S) ones and they struggled and started to oscillate.
Mount gets attached with two m3 screws and t-nuts. Servo arm is pushed on the original lever arm and screwed in place. interface print has place for a small magnetic screw and the arm has a cavity for a 6x3mm magnet.