Prusa MK3/MK4S Back Frame Storage Box (Strong & Secure)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A container with cover that can be attached to the back of the Prusa MK3-MK4S frame. Withstands firm pressure from above
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 365
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The box is fixed to the frame so that it does not need to be supported by the table. Outer dimensions: 247.2x99.8x52 mm (without hooks). It's possible to print both the box and the lid at once.
Before printing consider adjusting size of the hole in the cover. My fingers are quite big and they still have a little additional space, so you can leave it as it is as well.
I used PLA with 0.2mm layer, infill 100%. It worked well except the print warped on the corners. Consider gluing to the bed or raising temperature of the bed to avoid warping.
While printing, only hooks of the box need supports.
To fix the box to the frame of the printer first put the hooks on the frame and then move the box down until the protrusions will go under the frame. After being attached to the frame the box should not excced the level of the frame - make sure it does not block the movement of the heatbed.
Feel free to share your comments!
I tested it on my Original Prusa MK4S. Please, make sure your printer has the same dimensions of the frame as MK4S. You can check the dimensions here: https://www.prusa3d.com/page/open-source-at-prusa-research_236812/
If you'd like to customize your printer more, check out my other model:
https://www.printables.com/model/1306812-prusa-mk4-mk4s-heatbed-cable-top-cover-with-light