Minimal M-ATX Mount 10 inch Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is experimental mounting for 10 inch rack, but only hold where the screw placed.
- Ocena
- 0 / 5
- Polubienia
- 45
- Pobrania
- 302
- Wydruki
- 0
- Wyświetlenia
- 4982
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Warning!
This is experimental. I designed it for a specific setup where the motherboard doesn’t hold any heavy components and is intended to remain stationary (not mobile).
In my previous rack server design, due to the size limitation of my 3D printer (22cm x 22cm), I had to split the mount into two parts. This time, I try to create a new version that doesn’t require splitting.
I tested it with PLA at 20% infill and rail from https://www.printables.com/model/427461-10-inch-server-rack and it turned out quite sturdy. However, I recommend using stronger material and higher infill for better strength. In the photos, I didn’t use PCB standoffs I strongly suggest adding them to prevent soldering points from pressing against the printed base.