Beelink EQ12 Bottom Cover Fan Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for a Beelink EQ12 Bottom Cover with a standard 120mm fan at the bottom for top mounted purposes
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 498
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Made because I was worried about the temps on this machine running for a long time. Comes with mounting through holes for a 120mm fan. After multiple revisions after failure with magnets to join the two halves, I decided to just use dovetails to connect the two halves together. This setup has been running for now a year+ with no warping issues from the heat from the mini pc.
You will need to use the split function in your slicer with dovetails to separate the two halves (shortcut: C in prusaslicer) to make sure they fit properly and install each part separately before joining them together. You will also need a usb to PWM fan controller for your 120mm fan, or some other way to power them.
I used 35mm long screws with washers for the fan mounting (a Bequiet silent wings in this case), and the original screws from the backplate of the machine with small drilled holes for mounting of the base cover replacement to the machine. The PC is mounted to the underside of my table using command strips, but you can probably come up with a more creative/elegant solution.
This may work for other Beelink mini pc's but your mileage may vary.