Triple Threat Hot Shoe Mount

Hey everyone! So, I designed this little hot shoe multitool that you can 3D print, and I'm pretty stoked about it. Basically, it just pops right into your camera's hot shoe, and boom – you can now attach three accessories at the same time!

Seriously, if you're like me and always trying to figure out where to put your mic, or your flash, or that small monitor, this thing is a lifesaver. It keeps everything neat and tidy on your camera without needing a huge cage or anything fancy.

It's super handy for whatever you're doing – vlogging, making short films, or just snapping photos.

Here's what it's all about:

• Triple the fun: Slap on a mic, a flash, a monitor, or mix 'em up! Whatever hot shoe stuff you've got.
• Stays put: It's designed to fit snugly, so your gear won't go anywhere.
• Keeps it small: Adds more mounting spots without making your camera a giant mess.
• Easy to print: Should be a pretty straightforward print for most 3D printers.
• Super versatile: Great for almost any camera setup where you need a few extra things hooked up.

If you're gonna print it, here are some quick tips:

• Material: PETG or ABS are probably best for durability, but PLA might work if you're not putting heavy stuff on it.
• Infill: I'd go for around 20-30% for a good balance of strength.
• Supports: You might need a few, but probably not much.
• Layer Height: 0.2mm should be good.

Hope you guys find it useful! Let me know what you think if you print one.