Magewell USB Capture (Gen 1) Wire Shelf Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you wanted to hang your Magewell card off a wire shelf...this is for you!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
If this looks similar to the one I did for the EVGA XR1 Lite…well, I made them both at the same time while I had my nose in Tinkercad! The premise is the same: Get this poor capture card off my floor and mounted up to my wire shelf that my PC sits on. The gap for the hanger is the same (5mm) so please measure the thickness of your wire shelf before printing!
This is also meant for the side of the shelf with the larger gaps between the support rods (as spacing otherwise is, well, kinda inconsistent), usually this is either the rear or the front.
I made a cutout in the front mostly for heat dissipation, as these Magewell cards do like to run a bit toasty. Given that, I'd maybe consider printing this in PETG, but I tried PLA and it seems to be okayish for now.
Printed at 15% infill, oriented on its side as seen in the photo. Shouldn't need supports if your printer doesn't have problems with short bridges.