Parkside battery to Ryobi tool adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parkside battery adapter for Ryobi tool. Mixed two pieces of work together, I admit that. Did some modifications so…
- Ocena
- 4,778 / 5
- Polubienia
- 113
- Pobrania
- 1069
- Wydruki
- 13
- Wyświetlenia
- 7405
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
Parkside battery adapter for Ryobi tool.
Mixed two pieces of work together, I admit that.
Did some modifications so they fit together.
You need to print:
- 1x top
- 1x bottom
- 2x clip
And extra:
- 4x 6.3mm Faston male crimp connector, "blue" (accepts 1.5 - 2.5 mm2 cable) but without the plastic protective tubing
- 2x ~10cm cable (I advise 2.5 mm2)
- CA glue or any "fast" glue
- 1x some small spring (from a pen, split in half)
a)
- 4x M3 screws
- 4x metal M3 threaded inserts that you put in with heat (f.e. with soldering iron)
- you can also screw it in directly
b)
- or just glue it togehter :-) (but watch the alignment!)
Put the cable through the holes, crimp or solder the connectors, glue them in place. If something is tight, help it with a little heat (soldering iron), but be careful. It should work 99% straight out of the printer.
Connecting just the two connectors on each side (+ & -) works for the tool, but don't try to charge it with Ryobi charger. Charge the battery with Parkside charger only!
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
30
Filament: any PLA / PETG
Notes:
Top (tool part) and Clips can be printed without supports.
Bottom (battery part) piece require supports.
Origin - remix from:
https://www.thingiverse.com/thing:1248463
https://www.thingiverse.com/thing:3649747
https://www.thingiverse.com/thing:3114131
Category: DIY