HSW CanaKit Raspberry Pi Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a basic model to attach the Rpi to the HSW
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 227
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted something to mount my CanaKit Rpi5 on the HSW. I couldn't find a model that was going to do what I wanted with the CanaKit case still attached. So, I worked with @Jogner to put together this model. I've only tried it with the Rpi5, but I'm assuming it should also work with the Rpi4(b). I suspect that it should even be compatible with Rpi models with a full-sized HDMI cable.
It is a little loose in the holder. So, there's a lip to give it support at the bottom. I think it gives it some room for airflow. However, it wants to pull to towards the power and HDMI cables. I've found that giving those cables some slack and allowing a small amount of gravity pull from the keyboard/mouse cables seems to balance it out.
Print settings:
- 4 Perimeters
- 20% infill (I used Gyroid)