1 / 4
[IKEA ÖVERSIDAN] magnetic LED Clip v2.0 — zdjęcie 1
1 / 4

[IKEA ÖVERSIDAN] magnetic LED Clip v2.0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic clip mount for ÖVERSIDAN LED where usual mounting system can't be used (e.g. inside IKEA BROR cabinet)

Ocena
0 / 5
Polubienia
1
Pobrania
6
Wydruki
0
Wyświetlenia
147
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I use this clips for IKEA ÖVERSIDAN LED (wardrobe lighting strp w sensor) inside a IKEA BROR cabinet. The 60x3.5mm variant for the lower part (below the shelf), the 50x23.5mm variant for the upper part (below the top side).

You need per clip:

  • 2x countersunk head screw M3 x 10 
  • 2x insert M3 x 5 x 4.2
  • 1x Rectangular Pot Magnet w. 2x Counterbores, 50/60 x 13.5 x 5 (N35 should be fine)

NOTE: Do not tighten the screws too tightly (the magnet may split).

Easy mounting of this bracket to LED by slide on from side.

Printed with PET-G filament from FIBERLOGY (EASY PET-G).

Tagi