1 / 3
150mm Airconditon to 100mm wall vent adapter — zdjęcie 1
1 / 3

150mm Airconditon to 100mm wall vent adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

150mm air condition hose to 95mm wall vent (designed for 100mm wall vent)

Ocena
0 / 5
Polubienia
9
Pobrania
136
Wydruki
1
Wyświetlenia
439
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Needed an adapter for my argo swan evo airconditon for my wall vent.

Print in PETG, PLA will become too soft from the hot exhaust air. PETG with a heat deflection point of 71c seems to be holding strong. But I haven't had my AC on for longer than 5 hours during testing.

Also recommend either printing a TPU gasket or salvage one from the previous insert. I salvaged a rubber seal from the original Flexit 09169 wall vent

Mine was printed in 0.28mm with snug supports everywhere 15% gyriod infill using Clas Ohlson (FlashForge) PETG in black

 

NOTE: The flow rate for a 100mm tube is about 100-150m3. If your AC outputs more than this it will be working overtime to try to get that air out. Meaning your fan motors will be working overtime. There is a very real possibility on cheaper/low quality ACs that the fan motors will burn out. 

Tagi