1 / 6
Larger Spool Base and Door For Prusa Core One MMU3 Community Version — zdjęcie 1
1 / 6

Larger Spool Base and Door For Prusa Core One MMU3 Community Version

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Allows the use of spools with an outer diameter up to 208mm, increased from the original maximum of 202mm

Ocena
4,75 / 5
Polubienia
77
Pobrania
304
Wydruki
2
Wyświetlenia
3337
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The original models posted by @PrusaGuy are optimized to work with Prusament spools, however other spools are not guaranteed to be compatible.

My modified models allow PrintedSolid Jessie, Push Plastic, and Atomic spools to function in this spool holder solution. Although the door's negative volume diameter is smaller than that of the base spools with a larger diameter will still work well. The original mode's door is also smaller is maximum diameter than the base. The spool hangs off the conical feature in the center of the door when in the open state and tends to slide along the base when closed. 

Tagi