1 / 3
filament cutter arm for voron v0 - MG90 servo — zdjęcie 1
1 / 3

filament cutter arm for voron v0 - MG90 servo

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

servo actuated arm to pull the lever and cut the filament - designed for the dragon burner

Ocena
0 / 5
Polubienia
27
Pobrania
82
Wydruki
1
Wyświetlenia
975
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

after putting together my dragon burner's filament cutter I realized i needed a way to actuate it, so I searched and found the design by jack miller, but it didn't really fit my needs, by I liked the idea, so I used it as a a base to create my design.

 


MY klipper config for using this: (yours will not be the same, this is only an example, please use your brain when copying)

[mcu rp2350]
serial: /dev/ttyACM0

[servo testservo]
pin: rp2350:gpio2
initial_angle: 0
maximum_servo_angle: 180
minimum_pulse_width: 0.000500
maximum_pulse_width: 0.002500

[gcode_macro testservo_OFF]
gcode:
   SET_SERVO SERVO=wipeServo WIDTH=0 # OFF

[gcode_macro FC_deploy]
gcode:
   SET_SERVO SERVO=testservo ANGLE=180
   G4 P500
   testservo_OFF
   
   
[gcode_macro FC_retract]
gcode:
   SET_SERVO SERVO=testservo ANGLE=0
   G4 P500
   testservo_OFF


[output_pin my_led]
pin: rp2350:gpio25
value:1

[gcode_macro FC_CUT]
description: Run custom toolhead motion with arm deployment
gcode:
   {% set x_pos = printer.toolhead.position.x %}
   {% set y_pos = printer.toolhead.position.y %}
   {% set homed_axes = printer.toolhead.homed_axes %}

   # Ensure the toolhead is homed
   
   {% if 'x' not in homed_axes or 'y' not in homed_axes %}
   G28 X
   G28 Y
   {% endif %}
   
   G90 ; absolute positioning
   
   # Move to start position if not already there
   {% if x_pos <= 30 or y_pos >= 90 %}
   G1 X31 Y89 F6000            ; Move to starting position (X > 30, Y < 90)
   {% endif %}

   # Deploy the arm
   FC_deploy

   # Begin movement sequence
   G1 X30
   G1 Y120
   G1 X10
   G1 Y100 F3600
   G1 Y90 F300
   G1 Y100 F300
   G1 Y110 F3600
   G1 X30
   G1 X60 Y60

   # Retract the arm
   FC_retract
 

Tagi