Spektrum DX6 Shiftgate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For use with Tamiya 1:14 scale semi trucks using a 3 speed transmission
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I upgraded my Cascadia from an old Tamiya crystal radio to a Spektrum 6Ch one, and needed a shift gate to protect the truck's transmission.
This was designed for a G3 DX6, but may fit other Spektrum transmittors.
You'll need to adjust your throttle stick to be a bit longer to fit this properly, but should give you full use of your stick's range of movement. Stock rudder centering spring is not strong enough to pull it out of gear. Without the throttle center spring, above 50% throttle it stays at the throttle level and in the gear you set it to.
I printed it in PETG with 3 walls and 3 top/bottom layers, 15% gyroid infill
But my test prints seemed strong enough in PLA with 1 wall, 3 top/bottom layers.