1 / 8
Better Mount for Micro Swiss NG Direct Drive Extruder BL & CR Touch
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Uses the original metal mount for better stability and sturdiness to mount a BL or CR touch to the Micro Swiss NG DD
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Looking for a sturdy mount for your BL Touch or CR Touch to the Micro Swiss Direct Drive NG? Look no further! This adapter allows you to use the original metal arm that came with the CR touch for stability and sturdiness, and should not be affected by heat or length of usage due to the way it was designed.
Hardware required:
- M3 x 4mm or M3 x 6mm screw
- M3 nut
- Original screws that came with the direct drive
Print with PETG for better stability, but since the structural integrity comes from the metal arm, printing with PLA should be acceptable.
Instructions:
- Match the shape of the metal arm to the flat side of the printed adapter, and attach the top with the additional M3 screw and the additional M3 nut in the back.
- Use a provided M6 screw from the kit to go through the bottom hole of the arm, through the middle hole in the adapter, then attach both to the top hole of the mounting points in the extruder body.
- Use a provided M6 screw from the kit to attach the bottom hole of the adapter to the bottom hold of the mounting points in the extruder body.
- Ensure that the mounts are straight, the resting block in the back should provide easy alignment, then screw it tight.
- Attach your CR Touch or BL Touch to the metal arm.