Firefly Q6 (and Q7) Cineroc mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Firefly with a Cineroc profile...sort of.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 250
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
The Firefly mount for the Cineroc Tribute shell.
The shell isn't pretty but is solid and very functional giving you video resolutions of 4K 24fps, 2.5K 30fps, 1080P 60fps/30fps, 720P 120fps, VGA 30fps, when using the Q6 Firefly.
I print the parts at .2mm no infill and the camera shell does require supports (see the examples below)
You will need a 6.5" length of 6-32 all thread - but you don't have to if you're comfortable with using tape to hold the body together. You can use an actual 6-32 nut if you want, but I wanted something bulkier and easily tighten by hand, so I made the thumb nob.
The camera shell section can be separated into 3 parts so you can print stripes. This aids in giving you that classic Cineroc look.
The Bulkhead works to hold the camera in place, the all thread will have to bow around it but I've found it works just fine.
For assembly
- Insert camera into shell
- Press fit the bulkhead down onto the camera
- Put the nose cap on with the all thread down past the camera
- Fit the all thread into the base hole and then push the base up into the shell. Note: this illustration is a bit exaggerated in the bend.
Once mounted, you can easily access the USB charge and data port with the nose cap removed through the opening in the bulkhead. 