OVONIC Z-II Pro Charging Cradle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tilted, cable-organizing RC battery charger stand to improve display visibility and declutter your charging station.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
Keep your workspace neat and your charger accessible with this custom-designed stand for the Ovonic Z-II Pro dual-channel RC battery charger. This stand elevates your setup—literally and functionally—by providing an angled mount for better screen visibility and integrated cable management to reduce clutter.
🔧 Key Features:
Ergonomic Tilt: The angled cradle improves screen visibility, making it easier to monitor both channels of the charger.
Integrated Cable Storage: The lower compartment is designed to hold a variety of charge leads including XT60, Deans, EC3, JST, and balance plugs, keeping them within reach.
Optimized Ventilation: Designed to avoid blocking the charger's ventilation slots, ensuring safe and cool operation.
Stable & Secure: The charger sits snugly on top of the stand. Optional non-slip rubber feet or adhesive pads (not included) can be added for extra stability.
🖨 Print & Build Notes:
supports needed base sidewalls
Two-part design – prints flat and assembles easily by snapping or gluing the cradle onto the base.
Recommended material: PLA is sufficient, but PETG or ABS is recommended for higher heat environments.
Assembly tip: The fit is designed to be snug; sand pegs and holes lightly if the cradle to base fit is too tight.
Cable feed-through: There’s a rear opening to let power and balance wires pass through cleanly from the charger to your batteries.
Perfect for RC enthusiasts who value a clean, professional charging station. Give your Ovonic Z-II Pro a dedicated throne!
Inspired by a different cradle design I tried, but this model was created from scratch to better fit the Ovonic Z-II Pro charger and improve cable management.