1 / 5
Sliding Cover for Core One MMU3 Community, STEP files provided
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sliding cover for the pass through of the MMU3 unit into the chamber, to contain temperature und keep debrees out
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 97
- Wydruki
- 2
- Wyświetlenia
- 823
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 2) (Komentarze: 5)Remiksy (3)Kolekcje (57)Powiązane
I didn't like the fact that a large opening is on the top. Temperature would escape, and debrees of the filament cutter could fall into the build chamber, that's why I designed this cover.
- Use Structural settings, fast settings would lead to bad fitting
- Check the illustrated picture for assembly, orientation is important
- slide A-covers in from each side, then snap in the center piece in the middle, then snap in the B-covers from the top, interlocking with the center piece and overlapping with A-Covers
- I drilled 2,5mm holes in the base, and put in M3x8mm screws in directly. You could use longer screws and a nut, whatever works for you. I just did not want to reprint the base parts.
If you need other tolerances for smooth sliding, different hole for PTFE coupling or want to use a different mouting method, step files are provided as well.