Hand Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hand fan for keeping yourself cool. Uses 15g of filament and takes about 35 minutes to print.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Summer
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A simple hand fan. The included photos were printed in PETG, but I believe PLA should hold up just fine as well. Took 35 minutes to print and 15g of filament in my case.
It fits onto a Prusa Mini, but can be scaled up. However, if you choose to scale it up, be sure to NOT INCREASE/DECREASE THE Z HEIGHT! If you do this, the fan will become stiff, and will push less air. With that being said, the “sail” of the fan is 0.4mm thick, so it is IMPERATIVE that you use 0.2mm layers. Any larger, and the entire “sail” is a single layer, and will fall apart when you try to use it. Any smaller, and the “sail” will be stiff, and won't push air as well.