skull & co Neogrip switch 1 to 2 adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adapter replaces the spacer on the skull & co neogrip for switch 1/oled to make the grip fit the switch 2.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 86
- Wydruki
- 1
- Wyświetlenia
- 1239
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
UPDATE: Added a modified clip for those who want(ed) it. Hole on top is necessary to not block the light sensor controlling the automatic brightness of the console. Clip best printed on an angle.
This adapter makes use of the screws and holes for the spacer on the neogrip for switch (oled) to make it fit the nintendo switch 2.
Use this at you own risk. Although I haven't had any problems, I am not liable for any damage this may cause to the neogrip or your nintendo switch 2 system.
This requires the original screws for the neogrip, and although not necessary, ideally you'd add 3 more on top of those to fill all the holes.
I would also recommend covering the screws with an elastic tape, like electrical tape, afterwards. This minimizes the change of the screws scratching your console.
The original top clip doesn't work with the switch 2, but I haven't found it necessary to use.
The leek isn't part of the model, and was added by using a negative modifier in the slicer. This can be done without issues up to 1mm deep.
This is by no means a perfect replacement for grips made specifically for the switch 2. The switch 2 being taller than the original switch makes it so that the grips are slightly lower than they should be, and the grip blocks the kickstand. Although you can dock with the grip attached, I've found that it does flex the dock a little bit, and can't confirm the consequences of docking long-term.