Plug for screw holes 14 mm / parametric; For door & window frames; Vase mode
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A parametric model for plugs in door/window frames. 14 mm by default. Prints in vase mode.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
A parametric model for plugs in door/window frames. 14 mm diameter by default, but parametric in OnShape model. Prints in vase mode.
My old caps in my balcony door frame were crumbling, so I printed new in PETG. Optimised for 0.6 mm nozzle and 0.8 mm extrusion width, but should be printable on 0.4 mm nozzle with a 0.8 mm extrusion width as well.
Important Slicing Settings
- Print in vase mode, with the solid layers for the “cap”. At 0.15 mm layer height that I used, that is 8 solid bottom layers. (PrusaSlicer: Print Settings - Layers and perimeters)
- Set extrusion width for perimeters and external perimeters to 0.8 mm. (PrusaSlicer: Print Settings - Advanced)
- If you use concentric infill for the bottom infill pattern you can get better finish than in the photo, I switched to that later. (PrusaSlicer: Print Settings - Infill)
Parametric CAD
The original CAD can be found here. You can use the “configuration panel” on the right to select the variant (or add new ones if you make an editable copy of the document):
