GaggiMate smthng display housing 2 (with frame)

Before pushing the display into the housing, please make sure that the flat cable is centered over the cut-out. It is best to familiarize yourself with the installation instructions before installation (found in the files).

All smthng display housings for GaggiMate: https://www.printables.com/@dubios42/collections/2861668 
Housing 2 is the housing I personally recommend most for the LILYGO T-RGB, 2.1 inch, as it is the easiest to install, protects the display with its frame and I offer holder widths from 1.4 mm to 2.8 mm for it.

Support my work: https://ko-fi.com/modsmthng

smthng display housing 2 (with frame) for GaggiMate:

Holder widths from 1.4 mm to 2.8 mm, check print plate naming.
I marked the most suitable sizes with GC_P (Gaggia Classic / Pro - 1.4 mm) and RS (Rancilio Silvia - 2 mm).

How to install (no gluing or soldering necessary)
Instructions with pictures in the files

Before installation, it is best to assemble everything once without the display to test the functionality and then practice the installation with the display without the machine.

1. make sure that the cable for the display is as long as possible

2. feed the cable through the BASE from behind

3. place the base on the coffee machine

4. insert the display into the FRAME. The display is easiest to insert at a slight angle through the front of the FRAME.

5. plug the cable into the display

6. place the display in the BASE with the plug on the side and the ribbon cable pointing downwards. 
   Tip: The longer the cable, the easier this step is.

7. when the display is correctly positioned in the BASE, press the FRAME down.

How to print

• Base

  • It is best to print at a 45 degree angle without supports (Warnings due to floating regions can be ignored).

  • Or: If there are adhesion problems, the housing can also be printed flat on the back, but then supports should be activated.

• Frame

  • No supports