07'-08' Versys GPS Bar and 1" Ball Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
GPS Bar and 1" Ball Mount Adapter for 1st Gen Kawasaki Versys
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a GPS Bar mount and 1" Ball clamp adapter so I could run a cheap Carplay unit off my Versys
Note: The aluminum bar is 7/8" diameter, basically I simply cut off 140mm of the end of an old handlebar. Nice thing about this is anything that is made to clamp to a handlebar fits this GPS bar.
For the drill guide, it was only kind of helpful. I ended up using it just to mark the point on the bar to drill, then removing the guide and drilling a hole perpendicular into the bar. It just needs to be able to pass the M8 bolt so nothing crazy accurate.
Hardware:
2x - M8x45 BHCS (MUST be low head like a button head or else you may get windshield interference
2x - M8 nuts
2x - M5x20 BHCS/SHCS
2x - M5x25 BHCS/SHCS
4x - M5 x 4mm L x 7mm OD Heatset Inserts (I used these https://amzn.to/3Zp5HfC)
This is the Carplay unit I used. It has a molded in 1" ball but you can use anything ( https://amzn.to/4n0LWoI )