07'-08' Versys GPS Bar and 1" Ball Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
GPS Bar and 1" Ball Mount Adapter for 1st Gen Kawasaki Versys
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 24
- Makes
- 0
- Views
- 279
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
This is a GPS Bar mount and 1" Ball clamp adapter so I could run a cheap Carplay unit off my Versys
Note: The aluminum bar is 7/8" diameter, basically I simply cut off 140mm of the end of an old handlebar. Nice thing about this is anything that is made to clamp to a handlebar fits this GPS bar.
For the drill guide, it was only kind of helpful. I ended up using it just to mark the point on the bar to drill, then removing the guide and drilling a hole perpendicular into the bar. It just needs to be able to pass the M8 bolt so nothing crazy accurate.
Hardware:
2x - M8x45 BHCS (MUST be low head like a button head or else you may get windshield interference
2x - M8 nuts
2x - M5x20 BHCS/SHCS
2x - M5x25 BHCS/SHCS
4x - M5 x 4mm L x 7mm OD Heatset Inserts (I used these https://amzn.to/3Zp5HfC)
This is the Carplay unit I used. It has a molded in 1" ball but you can use anything ( https://amzn.to/4n0LWoI )