Umbrella Hole ring for Patio/picnic table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple ring designed to hold a pole in the center of a patio table.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 70
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
Got a new resin folding picnic table and umbrella. Noticed the umbrella was kinda loose in the center and moved a bit much even with a base holding it at the bottom. Designed this to fit around the umbrella pole and slide into the open space for a tighter fit. I printed it a few millimeter smaller than I need so it wouldnt be too difficult to put in or take out. Also, the model is a whole piece, but you can do a quick cut down the middle and print with center facing down like in the picture. I printed it like that with no support, 20% infill. Works well so far.