Umbrella Hole ring for Patio/picnic table
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple ring designed to hold a pole in the center of a patio table.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 16
- Makes
- 0
- Views
- 70
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
Got a new resin folding picnic table and umbrella. Noticed the umbrella was kinda loose in the center and moved a bit much even with a base holding it at the bottom. Designed this to fit around the umbrella pole and slide into the open space for a tighter fit. I printed it a few millimeter smaller than I need so it wouldnt be too difficult to put in or take out. Also, the model is a whole piece, but you can do a quick cut down the middle and print with center facing down like in the picture. I printed it like that with no support, 20% infill. Works well so far.